Clock Input Connector Selection; Clock Output Settings; Dimmer Setting - Esoteric D-02X Mode D'emploi

Clock input connector selection

CLKin>***
This selects the clock input connector .
By default, the setting is CLK .
CLK
In this mode, this unit can receive a clock signal through its CLOCK
SYNC IN connector from a clock generator and operate with clock
synchronization .
o The input impedance of the CLOCK SYNC IN connector is 75 Ω,
so TTL-level square wave signals can be input .
10M
In this mode, this unit can receive a 10MHz clock signal from a
clock generator connected to its 10MHz IN connector and operate
with clock synchronization .
o The audio source device must also be connected to the clock
generator or be connected to this unit's CLOCK SYNC OUT con-
nector and set to receive clock synchronization .
o The input impedance of the CLOCK SYNC 10MHz IN connector
is 50 Ω, so sine wave signals with 0 . 5 –1 . 0 Vrms amplitude levels
can be input .

Clock output settings

CLK_TH>***
This sets the clock output during clock input mode .
By default, the setting is OFF .
OFF
No clock signal is output from the CLOCK SYNC OUT connector .
ON
Clock with the same frequency as the input clock is output from
the CLOCK SYNC OUT connector .

Dimmer setting

DIMMER>***
You can adjust the brightness of this unit's display and indicators .
By default, the setting is 2 .
Dimmer3
c
(normal brightness)
Dimmer2
c
Dimmer1
c
Off
o The dimmer of this unit can be adjusted using the DIMMER but-
ton of a remote control included with a P-02X or other Esoteric
product .
o Even when set to Dimmer1 or Off, a brighter setting (Dimmer2 or
Dimmer3) will be used when displaying error messages and set-
ting menus .
15