Clock Output Setting; Dimmer Setting; Automatic Display Darkening Setting; Automatic Power Saving Setting - Esoteric D-05X Mode D'emploi

Setting mode (continued)

Clock output setting

CLK_TH>***
This sets the clock output when in a clock input mode (CLK>IN, MCK
IN and MCK10M) .
By default, the setting is OFF .
o This setting can be made for each input .
OFF
No clock signal is output from the CLOCK SYNC OUT connector .
ON
Clock with the same frequency as the input clock is output from
the CLOCK SYNC OUT connector .

Dimmer setting

DIMMER>***
You can adjust the brightness of this unit's display and indicators .
By default, the setting is 2 .
DIMMER>3
c
DIMMER>2
(normal brightness)
c
DIMMER>1
c
DIMMER>0 (off )
o The dimmer of this unit can be adjusted using the DIMMER but-
ton of a remote control included with a P-05X or other ESOTERIC
product .
o Even when set to DIMMER>1 or DIMMER>0 (off ), a brighter set-
ting (DIMMER>2 or DIMMER>3) will be used when displaying error
messages and setting menus .
16

Automatic display darkening setting

DPaOFF>***
You can set the display to darken automatically after a set amount of
time has elapsed .
By default, the setting is ON .
ON
The display will automatically darken after 10 minutes elapse with-
out any operation or change in the information shown .
OFF
The display will not automatically darken, but if nothing changes
for 10 minutes, its brightness will be lowered to the level of
DIMMER>1 to reduce long-term display fading .
o We recommend setting this to ON because brightness irregulari-
ties might occur if the same information is shown without change
on the display for a long time .

Automatic power saving setting

APS>***
The unit can be set to turn off automatically if the set amount of time
elapses without being able to lock to a digital signal from an input
source .
o By default, the setting is 30m .
o The input sources that are not selected have no effect on auto-
matic power saving .
30m
30 minutes
60m
60 minutes
90m
90 minutes
120m
120 minutes
OFF
The automatic power saving function is disabled .