Names And Functions Of Parts (Display) - Esoteric D-05X Mode D'emploi

Names and functions of parts (display)

a b
ESL3 DSD DIRECT
E S L I N K
e
a
Input format
ESL1:
This appears when a DSD signal in ES-LINK1 format is being
received .
ESL2:
This appears when a DSD signal in ES-LINK2 format is being
received .
ESL3:
This appears when a 48-bit PCM signal in ES-LINK3 format is
being received .
DoP:
This appears when a DSD signal in DoP (DSD Audio over PCM
Frames) format is being received .
No indicator:
Nothing appears when S/PDIF signals are being received,
when PCM signals are being received over a USB connection
or during ES-LINK input .
b
Upconversion setting
No indicator:
The upconversion function is not in use .
UPCONV 2Fs:
The upconverter circuit will upconvert the signal to 64, 88 . 2
or 96 kHz before digital to analog conversion .
UPCONV 4Fs:
The upconverter circuit will upconvert the signal to 128, 176 . 4
or 192 kHz before digital to analog conversion .
UPCONV 8Fs:
The upconverter circuit will upconvert the signal to 256, 352 . 8
or 384 kHz before digital to analog conversion .
UPCONV DSD:
The upconverter circuit will convert the PCM signal to a DSD
signal before digital to analog conversion .
DSD DIRECT:
If DSD_F (DSD filter) is set to OFF, this appears when a DSD
signal is input .
c d
MCK IN 10MHz
3 5 2
f
c
Clock mode
No indicator:
Nothing is shown when CLK is set to OFF .
CLK OUT:
Shown when CLK is set to OUT .
The frequency display area shows the output clock frequency .
CLK IN:
Shown when CLK is set to IN .
The frequency display area shows the input clock frequency .
MCK IN:
Shown when CLK is set to MCK IN .
The frequency display area shows the input clock frequency .
INTERNAL:
Shown when the internal clock is being used with USB input .
d
Clock frequency
e
Input
f
Sampling frequency
This shows the sampling frequency of the input signal .
o When the input source is ESLINK, this shows the input signal
format (PCM or DSD) .
11