ESTEBAN PARIS EASY POP EDITION Notice D'utilisation page 9

REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
No mist when the
appliance is switched on
Mist stops while
the diffuser
is in operation
Insufficient mist
The light does not
switch on
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
Power supply
Mains
Power
Causes
The appliance is not plugged in
Water level too low
Water level exceeds 100 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops in the part A
The ceramic disk is dirty
An excess of Estéban refresher oils or essential
oils has been poured into the container
Accumulation of water drops in the part A
Diffuser failure
USB 3 / 5V - 1A
Compatible with USB mains adapter – Output: 5V
5 W
Solutions
Ensure that the USB lead is correctly connected to the device
and the USB port
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the mist
Fill the water container
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Clean the ceramic disk as described in the « PRECAUTION
FOR USE » instructions
Empty the appliance and clean it
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Bring the diffuser back to the retailer within the after-sales
service support legal deadline
1A
9