User Interface - Bosch GDS18V-740C Mode D'emploi

2610067376 08-21 GDS18V-740C.qxp_GDS18V-770 8/18/21 7:00 AM Page 20
Driving nuts and bolts
Use variable speed control with caution for
driving nuts and bolts with socket
attachments. The technique is to start
slowly, increasing speed as the nut or bolt
runs down. The nut or bolt is set when the
socked comes to a stop.
Note: Ensure that no metal particles enter
the power tool. After working at a low
speed for an extended period, you should
operate the power tool at the maximum
speed for approximately three minutes
without load to cool it down.
Cold weather use (32°F)
Due to the lubrication used in the
impacting mechanism, the tool should be
run for three minutes at no load prior to
actual usage. This will warm the lubricant
and provide better performance.

User interface

Status indicator LED
The LED bar at the top of the user interface
illuminates in various colors to help the
user identify the status of the tool. When
the status indicator LED (12) is green, the
tool and battery pack are operating
normally and temperatures are ok. If the
indicator changes to yellow, it means that
the tool or battery temperatures have risen
to a high level, and the use of the tool must
stop to allow the tool to cool off. It is best
to back off the load and give the tool
chance to cool down. If the indicator turns
red, the tool will shut off to protect itself
and/or the
overheating situation.
The status indicator LED (12) will also blink
blue when the speed (14) or mode (16)
buttons are held for 7 seconds. This will
reset the tool settings to factory default.
Operating Instructions
battery pack from
Joist Hanger
that the accessory is exposed. Always hang
the tool in an area where yourself and
bystanders cannot accidently make contact
with the accessory.
joist hanger if it appears damaged or
deformed. This could result in unstable
hanging and the tool unexpectedly falling.
selecting the location for hanging the tool.
The optional joist hanger accessory (4) will
allow you to conveniently attach your tool
to a joist, or other convenient support
when not in use.
The joist hanger (4) can be attached to
either side of the tool by securing it with a
mounting screw. Always make sure you
securely tighten the mounting screw before
use (Fig.1).
• Select a suitably sized and shaped object
that will provide
stability. An unstable hanging surface
could result in the tool unexpectedly
falling.
• Ensure that the tool is hung out of the way
of walkways and working areas with
bystanders. The tool could be bumped or a
bystander could become entangled
causing the tool to unexpectedly fall.
an
20
When using the joist
hanger always be aware
To reduce the risk of
injury, Do not use the
To reduce the risk of
injury, use care
adequate hanging
in