Hayward AQUARITE FLO ADVANCED Guide De L'utilisateur page 22

Connection
Dry contact
For set-up and connection of a
Variable Speed Pump, see section
on Filtration / Variable Speed
Pumps.
7.3
7.4
7.5
Page 8 of 12
7. FILTRATION – Manual mode
7.1 Filtration:
Configuration of the filter pump
control. To configure this, select
Filtration and confirm by pressing
OK . A mode is selected
from the Mode listing, using the
plus/minus keys.
7.1. FILTRATION – Automatic mode
7.3 Automatic (or with timer):
In this mode the filtration is switched on in accordance with timers that allow adjustment of the start and end times of the filtration. Timers always
operate daily, in cycles of 24 hours.
To set the ON/OFF times (configuration of up to 3 times possible), use the up/down keys in the timer line that you want to change (1-3).
Open the start time input field for the selected timer using the plus/minus keys. Set the time with plus/minus keys. Use the up key to scroll up to the
minutes input field and set this using plus/minus keys. To confirm press OK and to cancel press return/escape. To set the OFF timer, proceed in the
same way.
See section Filter Cleaning below.
7.2. FILTRATION – Smart mode
7.4 Smart*: This mode is based on the automatic or timer mode, with its 3 filtration intervals, but with adjustment of the filtration times as a function
of the water temperature. Two temperature parameters are provided for this: the maximum temperature, above which the filtration times will be those
set by the timers, and the minimum temperature, below which the filtration time will be reduced to 5 minutes, which is the minimum operating time.
Between these 2 temperatures the filtration times increase linearly. Use the plus/minus keys to set the desired minimum and maximum temperatures.
There is the option of activating the antifreeze mode which sets the filtration to run continuously if the water temperature is below 2 °C.
To set the ON/OFF times (configuration of up to 3 times possible), follow the instructions for the Automatic Mode.
See section Filter Cleaning below.
* N.B.: Mode only visible when the option to use temperature probe and/or heating is activated in the "Installer Menu".
7.3. FILTRATION – Filter cleaning
7.5 Filter cleaning mode (and pool cleaning by suction): From this menu (accessible from any Filtration Mode) a backwash cleaning of the sand filter
can easily be carried out. Activating this menu from any filtration mode (Manual, Automatic, Smart), will disconnect the electrolysis/hydrolysis cell.
Then proceed as follows:
• Turn the filter pump OFF using the plus/minus keys.
• Place the filtration pump valve in the backwash cleaning position.
• Turn the filtration pump back ON. You can check the duration of the backwash cleaning by looking at the clock on the screen. Make sure an
adequate and complete backwash of your filter has been carried out.
• When you have finished the backwash cleaning, again turn the filtration pump OFF and put the valve back in the filtering position. If you wish, you
can now perform a rinse cycle.
• Proceed in the same way as for backwash cleaning, this time placing the filtration pump valve in the rinsing position.
• When exiting the Filter Cleaning menu using the return/escape key, the system will revert back to the mode programmed previously.
USE ONLY GENUINE REPLACEMENT PARTS
AquaRite Flo Advanced
7.1
7.2 Manual:
Manually turns the filtration process
ON or OFF. No timing or additional
functions. The Status line indicates
whether the filtration pump is ON
or not.
See section Filter Cleaning below.
7.2
Rev. A