Technical Data; Battery Charging - Bosch GSR Professional Serie Notice Originale

OBJ_BUCH-720-001.book Page 9 Monday, May 5, 2008 8:55 AM

Technical Data

Cordless Screwdriver
Article number
Rated voltage
No-load speed
– 1st gear
– 2nd gear
Max. torque for
hard/soft screwdriving
application according to
ISO 5393
Max. drilling dia.
– Steel
– Wood
Max. screw dia.
Chuck clamping range
Drill spindle thread
Weight according to EP-
TA-Procedure 01/2003
Technical data determined with 2.0 Ah NiCd battery.
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
Assembly

Battery Charging

A new battery or a battery that has not been used
for a longer time produces full power only after
approximately five charge/discharge cycles.
To remove the battery 6, press the unlocking but-
tons 5 and pull out the battery downwards. Do
not exert any force.
The battery is equipped with an NTC tempera-
ture control which allows charging only within a
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Bosch Power Tools
GSR ... 12 V
Professional
3 601 J95 ... 5.0
V= 12
0 – 400 0 – 400
rpm
rpm 0 – 1400 0 – 1400
Nm 34/20
mm 10
mm 25
mm 7
1.5 – 10 1.5 – 13
mm
½"
kg 1.8
Changing the Tool (see figure A)
The drill spindle is locked when the On/Off
switch 8 is not pressed. This makes quick, conve-
nient and easy changing of the tool in the drill
chuck possible.
Open the keyless chuck 1 by turning in rotation
direction
the tool.
Firmly tighten the collar of the keyless chuck 1 by
hand in rotation direction
tion ("click") is no longer heard. This automati-
cally locks the chuck.
12 V 14,4 V 14,4 V
5.1 4.0 4.1
12 14.4 14.4
0 – 400 0 – 400
0 – 1400 0 – 1400
36/20 38/22 42/22
13 10 13
28 32 35
7 8 8
1.5 – 10 1.5 – 13
½" ½" ½"
1.9 1.9 2.0
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
until the tool can be inserted. Insert
1 609 929 R34 | (5.5.08)
English | 9
18 V 18 V
3.0 3.1
18 18
0 – 450 0 – 450
0 – 1450 0 – 1450
42/28 48/28
10 13
32 36
8 8
1.5 – 10 1.5 – 13
½" ½"
2.0 2.1
until the locking ac-