Table des Matières
Publicité
CLLIODA600RGB / CLLIODA1000RGB System Settings - terms and explanations
Display
ON
OFF
5S
15S
Master
ON
OFF
Laser
Size 10 - 128
Colour
InvertX ON
InvertX OFF
InvertY ON
InvertY OFF
TTLMode ON
TTLMode OFF
Default
Test Pattern
CLLIODA400RGY System Settings menu
Setup
ENTER -> UP/DOWN
22
=
Display light is permanently on
=
Display light is permanently off
=
Display light turns off after 5 seconds of inactivity
=
Display light turns off after 15 seconds of inactivity
=
Master/Slave mode: DMX signals will be output
=
Master/Slave mode: DMX signals will not be output
Note on the master/slave mode: Master unit: Master ON
=
Setting the maximum size of the laser projection
=
RGB = entire colour spectrum. RGY = red, green and yellow.
=
Movement direction of the X-axis is reversed
=
Standard movement direction of the X-axis
=
Movement direction of the Y-axis is reversed
=
Standard movement direction of the Y-axis
=
Limitation of the projection colours to
red, green, blue, yellow, cyan, magenta, white
=
RGB colour mixing (analogue modulation)
=
Reset to factory setting
=
Test projection and setting the speed of stepper motors
from 10 Kpps to 30 Kpps (Kilo points per second)
Display
ENTER -> UP/DOWN
Master
ENTER -> UP/DOWN
Laser
ENTER -> UP/DOWN
Default
ENTER
Test Pattern
ENTER -> UP/DOWN
Slave unit: 4-CH Mode
ON
OFF
5S
15S
ON
OFF
Size
InvertX
InvertY
TTLMode
Scanner 10 - 30KPPS
ENTER -> UP/DOWN
Size 10 - 128
ENTER -> UP/DOWN
ON
OFF
ENTER -> UP/DOWN
ON
OFF
ENTER -> UP/DOWN
ON
OFF
Publicité
Table des Matières
