Fox RX+ micron Mode D'emploi page 9

Warnings
• DO NOT trigger LED or speaker in close proximity to human or
animal eyes and ears.
• Store this equipment out of reach of children and infants.
• Avoid dropping or subjecting the Micron to severe impacts.
• Use only recommended batteries and accessories.
Drying Out After Use in Heavy Rain
The RX+ Micron has been designed to be weatherproof. However, after
use in heavy rain, it is important to allow the unit to dry out properly by
bringing the unit indoors and removing the hard case cover.
NEVER place batteries in a hot environment (e.g. on a radiator).
Compression Washers
The RX+ Micron is supplied with 2 styles of compression washer. A
conventional rubber O ring and a 2 piece rigid design.
The 2 piece rigid design has the ability to offer 4 different thicknesses
depending on the how they are pushed together.
To use this washer start with the washer in its thinnest configuration.
Snap the halves together as per image (A). Place this on the thread of
the alarm and attach the alarm to your chosen mount. If the thread
tightens at the wrong angle reverse these steps and rotate the top
half of the washer anticlockwise aproximately12° (image B) and snap
together. The washer should now resemble image (C).
If the alarm still does not tighten to the desired angle there are 2 more
follow step 2 and retry the washer in the 3rd height (image D) and
finally the 4th height (image E) should the 3rd height not be correct.
A B
ENGLISH
C D E
9