Connecting Up; Rear Panel; Front Panel; Making Cable Connections - Pioneer PDX-Z9 Mode D'emploi

Connecting up

02
Chapter 2
Connecting up

Rear panel

1
1 AC IN - Power inlet
Connect the supplied power cable (page 11).
2 LINE IN/OUT jacks
Connect an external component. To listen to components
connected to the LINE IN jack, press INPUT on the
remote control to select LINE (page 9).
3 PHONO IN jacks
Connect a turntable. To listen to audio from a connected
turntable, press INPUT on the remote control to select
PHONO (page 9).
4 SIGNAL GND terminal
If your turntable has a grounding wire, connect it here to
reduce undesired sounds (page 9).
5 iPod IN terminal
Connect the provided iPod control cable here (page 9, 22) .
6 LAN (10/100) terminal
Use provided LAN cable to connect to network ( page 9 ,
21 ).
7 AM LOOP antenna terminal
Connect provided AM loop antenna here (page 10).
8 FM antenna socket
Connect provided FM wire antenna here (page 10).
9 SPEAKERS terminals
Connect the speakers here (page 11).
8
En
SIGNAL
GND
L
AC IN
R
OUT IN IN IN
LINE
PHONO iPod
2 3 4 5
ANTENNA
AM
FM UNBAL 75
LOOP
LAN
(10/100)
6 7

Front panel

LAY OFF SOUND RETRIEVER
USB
1
1 USB interface
Connect a USB mass storage device for playback
(page 9, 21).
2 F.AUDIO IN jack
To listen to audio from an external component, connect
with a stereo mini-plug cable. Once connected, the input
automatically changes to FRONT AUDIO IN (page 9).

Making cable connections

Make sure not to bend the cables over the top of this unit.
This may cause a humming noise from the speakers.
Important
• Before making or changing any connections, switch
off the power and unplug the power cord from the AC
outlet.
SPEAKERS
R L
8 9
F. AUDIO IN PHONES
2