Pioneer PDX-Z9 Mode D'emploi page 39

Additional information
Home Media Gallery
Symptoms
Cannot access the network.
Playback does not start while
'Connecting...' continues to
be displayed.
The PC or Internet radio is not
properly operated.
The audio files stored on
components on the network,
such as a PC, cannot be
played back.
Audio playback is undesirably
stopped or disturbed.
Causes
The LAN cable is not firmly connected. Firmly connect the LAN cable (see page 21).
The router is not switched on.
Internet security software is currently
installed in the connected component.
The audio component on the network
which has been switched off is
switched on.
The component is currently
disconnected from this receiver or the
power supply.
The corresponding IP address is not
properly set.
The IP address is being automatically
configured.
Windows Media Player 11 is not
currently installed on your PC.
Audio files were recorded in formats
other than MP3, WAV (LPCM only),
MPEG-4 AAC, FLAC, and WMA.
Audio files recorded in MPEG-4 AAC or
FLAC are being played back on
Windows Media Player 11 or Windows
Media Connect.
The component connected to the
network is not properly operated.
The component connected to the
network does not permit file sharing.
The folder stored on the component
connected to the network has been
deleted or damaged.
The audio file currently being played
back was not recorded in a format
playable on this receiver.
The LAN cable is currently
disconnected.
There is heavy traffic on the network
with the Internet being accessed on the
same network.
Remedies
Switch on the router.
There are cases where a component with Internet
security software installed cannot be accessed.
Switch on the audio component on the network
before switching on this receiver.
Check whether the component is properly
connected to this receiver or the power supply.
Switch on the built-in DHCP server function of
your router, or set up the network manually
according to your network environment.
See Setting up the network on page 30.
The automatic configuration process takes time.
Please wait.
Install Windows Media Player 11 on your PC (see
page 22).
Play back audio files recorded in MP3, WAV
(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
that some audio files recorded in these formats
may not be played back on this receiver.
Audio files recorded in MPEG-4 AAC or FLAC
cannot be played back on Windows Media Player
11 or Windows Media Connect. Try using another
server.
Refer to the operation manual supplied with your
server.
Check whether the component is affected by
special circumstances or is in the sleep mode.
Try rebooting the component if necessary.
Try changing the settings for the component
connected to the network.
Check the folder stored on the component
connected to the network.
Check whether the audio file was recorded in a
format supported by this receiver (page 29).
Check whether the folder has been damaged or
corrupted.
Note that there are cases where even the audio
files listed as playable on this receiver cannot be
played back or displayed.
Connect the LAN cable properly.
Use 100BASE-TX to access the components on
the network.
10
39
En