Publicité
Les langues disponibles
Les langues disponibles
When "3" is substituted to "A":
1.
Issuing a general Z1 report
2.
Issuing a general Z2 report
3.
Resetting GT
4.
Setting "not printing" for a PGM function "Printing exchange total amount and change amount on receipt or
journal"
5.
Setting "multiplication" for a PGM function "Exchange calculation method"
6.
Changing the domestic currency symbol to the EURO symbol ( ) and setting the number of digits after
decimal of the domestic currency amount to 2
7.
Setting the round-off function for currency exchange
After the execution of the procedure with the substitution of "3", treat EURO as domestic currency.
When the operation with the substitution of "2" has been performed already, "3. Resetting GT" is not executed.
When the operation with the substitution of "1" or "2" has been performed already, the currency symbol of
exchange key is overwritten with a space.
• If you want to check the current status you are in, set the manager key (MA) to X2/Z2 position,
and use the following sequence.
800
Optional Programming for the Introduction of EURO
Some programming relating with the function of exchange key (
execution of modification operation described in the previous section.
Currency exchange rate for
For period 1 and period 2, set the EURO conversion rate. For programming details, refer to "Programming the
rate".
Exchange rate entry selection
When you treat EURO currency in the exchange key, you must apply preset rate entry. So, make enable for
preset rate entry for period 1 and period 2. For programming details, refer to "Programming function parameters
e
for
key".
Cheque/credit operation
For period 1 and period 2, enable cheque/credit operation when tendering in foreign currency so that you can
treat cheque and credit for EURO currency and national currency. For programming details, refer to
"Programming EURO system setting".
Displaying the Change Amount in Exchange Currency
You can display a change amount in exchange currency by pressing the
displayed. This may be convenient when you want to give the change in exchange currency in the period 1 and
2. When pressing the
The conditions that you can display a change amount in exchange currency are as follows:
• "Printing" is selected for a PGM function "Printing exchange total amount and change amount on receipt or
journal.
• Exchange rate is not zero.
36
Downloaded from:
http://www.usersmanualguide.com/
≈
e e
key
e
key again, the displayed amount returns to the amount in domestic currency.
É
e
) cannot be changed automatically with the
Current status
e
key when the change amount is
Publicité
