TaoTronics TT-BH17 Mode D'emploi page 38

EN The Bluetooth®word mark and logos are registered
trademarks owned by the Bluetooth SIG, Inc. and any
use of such marks by Sunvalleytek International Inc. is under license.
Other trademarks and trade names are those of their respective owners.
DE Die Marke Bluetooth®und das Bluetooth Logo sind eingetragene
Markenzeichen der Bluetooth SIG, Inc. und jegliche Verwendung dieser
Marke durch Sunvalleytek International Inc. ist lizensiert. Die Rechte an
anderen Markenzeichen liegen beim jeweiligen Eigentümer.
FR Le terme et les logos Bluetooth®sont la propriété de Bluetooth SIG,
Inc. et toute utilisation de ces marques par Sunvalleytek International
Inc. se fait sous licence. Les autres désignations commerciales et
marques mentionnées sont détenues par leur propriétaire respectif.
ES La marca Bluetooth®y los logotipos son de propiedad de Bluetooth
SIG, Inc. y se encuentra autorizado cualquier uso de estas marcas por
parte de Sunvalleytek International Inc. Otras marcas y nombres
comerciales son aquellas de sus respectivos propietarios.
IT La parola e i loghi Bluetooth®sono marchi di fabbrica registrati di
proprietà di Bluetooth SIG, Inc. e qualsiasi utilizzo di questi marchi da
parte di Sunvalleytek International Inc. avviene su licenza. Gli altri
marchi di fabbrica e nomi commerciali appartengono ai rispettivi
proprietari.
のワードマークおよびロゴはBluetooth SIG, Inc.が所有する登録
JP Bluetooth
®
商標であり 、 Sunvalleytek International Inc.はこれらのマークおよびロゴをライ
センスに基づいて使用しています。 その他の 商標およびトレードネームは、 それぞ
れの所有者に帰属します。
MADE IN CHINA
NOTE: This equipment has been tested and found to comply with the
limits for aClass B digital device, pursuant to part 15 of the FCC Rules.
These limits aredesigned to provide reasonable protection against
harmful interference in aresidential installation. This equipment
generates uses and can radiate radiofrequency energy and, if not
installed and used in accordance with the instructions,may cause
harmful interference to radio communications. However, there is
noguarantee that interference will not occur in a particular installation.
If thisequipment does cause harmful interference to radio or television
reception, whichcan be determined by turning the equipment off and
on, the user is encouraged totry to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which thereceiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modi cations not expressly approved by the party
responsible for compliancecould void the user's authority to operate
the equipment. This device complies with Part15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and(2) this device
must accept any interference received, including interference that
maycause undesired operation.