Operation - Lacor Magnetic 69398 Conseils D'utilisation Et D'entretien

1.- The body of the heating base (8) has two compartments on the bottom where the accessories
are stored magnetically.
2.- Choose one of the two accessories (9), the frothing attachment for frothing milk or the heating
attachment to just heat milk. Gently pull the accessory you need and put it on the metal
axle inside the glass pitcher (2).
3.- Put the body of the heating base on a flat level surface and plug it into an outlet compatible
with the device.
4.- Pour some milk into the pitcher and put it on the heating base (4). Close the pitcher with the
lid (1).
WARNING:
The amount of milk in the pitcher cannot exceed the MAX line on the
pitcher.
5.- Before starting up, make sure to place the correct accessory, stirrer or foamer, inside the jug.
Add milk without exceeding the MAX mark and press any of the buttons according to your
choice, shake cold, shake hot or froth hot.
NOTE:
The attachment rotates using a patented system of magnets located in the base.
6.- With any of the previous functions, the device will stop automatically (3 min) when the milk has
been heated and the froth has been made.
WARNING:
Do not run the device while empty. The device will stop automatically if there
is no milk inside the pitcher.
7.- After the indicator light turns off, lift the pitcher and pour the contents.
WARNING:
If you've used the heating function the pitcher will be very hot. Grab
the pitcher by the handle (3) to avoid getting burned.
8.- Unplug the item before storing.
1.- Make sure the device is unplugged before starting to clean it.
2.- Take the pitcher off the heating base. The heating base cannot be submerged. Use a damp
cloth to clean it and then dry it off.
3.- Remove the lid and whatever attachment was used. Wash the pitcher and attachment with
soap and water. Those parts are not dishwasher safe. Do not ever use abrasive products to
clean the item.
4.- Dry all the parts before storing them. Store all the attachments in the bottom of the device, in
the storage area.
5.- Put the pitcher with the lid on back on the heating base and store the device.

OPERATION

CLEANING
33