Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
28
www.electrolux.com
10. Tighten the hinge.
11. Put the top in position.
12. Push front the top.
13. Screw both screws on the rear side.
14. Remove and install the handle on the
opposite side.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
10. NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
All manuals and user guides at all-guides.com
1
2
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
• The door opens and
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest After
Sales Service Force. The
After Sales Service
specialist will carry out the
reversibility of the doors at
your cost.
9.6 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
3
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
adheres to the cabinet.
closes correctly.
Publicité
Table des Matières
