Active Symbologies - Datalogic PowerScan RF SR Guide De L'utilisateur

Active
Symbologies
User's Guide
LED
INDICATION
Continuous flashing
Lit Constantly
Charge
(Battery)
Not Lit
Lit Constantly
Power
a. The LED remains on while the unit is actively processing code which
requires a TX/RX to occur. The duration of the LED is dependent upon
the length of the message.
The active (enabled) bar code symbologies in the standard factory
defaults are:
•
Code 39 (C39)
•
Code 128 (C128)
•
Interleaved 2 of 5 (I 2 of 5)
Your scanner should be pre-programmed with these standard factory
default settings, unless...
...it was shipped to you programmed with unique, customer con-
figuration settings.
...you or another user have made changes to scanner program-
ming.
DURATION COMMENT
When a scanner is nested
in the station, this indicates
its battery is being quick
charged.
When a scanner is nested
in the station, this indicates
its battery is at or near full
charge.
A scanner is not present or
incorrectly inserted into the
station. It can also mean
the battery is below 0°C
(too cold for charge)
Indicates that power is on.
21