Disposing Of Batteries; Four Station Charger - Datalogic PowerScan RF SR Guide De L'utilisateur

Disposing of
Batteries
Four Station
Charger
Figure 5. Using the Four Station Charger Accessory
1. Device Power LED
12
There presently are no US, North America or World disposal require-
ments for NiMH batteries, so when they won't hold a charge anymore,
the batteries can be disposed of, preferably through a recycling center.
If you have a Four Station Charger, batteries are inserted for charging
as shown in Figure 5. A 90% rapid charge can be achieved in only two
hours when using this optional accessory, half the time than when a
Base Station is used for charging. The LEDs at each battery station
operate the same as the CHARGE LED on the Base Station, with rapid
flashing indicating that rapid charging is taking place and on steady
during trickle charging or when the rapid charge cycle is finished.
If you insert a battery into the Four Station Charger
and no LEDs illuminate, the battery may be too
cold. Batteries must be at 0°C or higher to charge.
Do not attempt to charge cold batteries, since plac-
ing them in the charger will curtail the charging of
NOTE
other batteries already present in the unit.
1
2. Station Charge LEDs
2
®
PowerScan RF Scanner