Troubleshooting Table - Kohler K-99696 Guide D'installation Et D'entretien

Troubleshooting (cont.)

Troubleshooting Table

Symptoms Probable Cause
One or both A. Speaker cable is
1.
speakers do
not produce
sound, or
sound is too
low in a two
speaker setup.
2. One or more A. Damaged speaker
speakers do
not produce
sound, or
sound is too
low in a four
speaker setup.
B. Speaker cable is
3. After playing A. Thermal shut
music loudly,
the music stops
even though a
song is
properly
selected.
4. The status LED A. Power supply is
is not
illuminated.
B. Power supply
C. The outlet is not
D. Circuit breaker has
Kohler Co.
Recommended Action
A. Make sure the cables
not plugged in are properly installed
properly. into the amplifier
connections and to
the left and right
speakers.
A. Make sure the
or speaker not speaker cables are
plugged in. properly installed
into the appropriate
positive (+) and
negative (-)
connectors on the
amplifier.
B. Connect 4 Ohm
not connected speakers in series
properly. and 8 Ohm speakers
in parallel.
A. Shut down the
down. system for 1 hour to
allow the unit to
cool. Make sure the
area where the unit
is installed does not
exceed 104°F (40°C).
A. Plug the power
not plugged into supply into the
the outlet. outlet.
B. Check power supply
connection to the connection to the
amplifier may be amplifier and
loose or reconnect if needed.
disconnected.
C. Make sure there is
powered. power to the
electrical outlet.
D. Reset the circuit
been tripped. breaker.
13 1232038-2-A