Speaker Connections - Kohler K-99696 Guide D'installation Et D'entretien

Series Connection - 4 Ohm
+ - - + + -
+ - - +
R L
Speaker Terminal

4. Speaker Connections

NOTE: This amplifier allows 2- or 4-speaker stereo output. Refer to
the connection diagram above for your wiring configuration.
NOTE: The speaker terminal will accept a 12-24 AWG wire. Follow
local codes for routing speaker wires.
Disconnect the power from the amplifier.
Using a wire stripper, remove approximately 1/2" (13 mm) of
insulation from the speaker wire.
Insert the wire into the appropriate positive (+) or negative (-)
and right (R) or left (L) terminal connector.
Repeat for the remaining speaker wires.
Reconnect the power to the amplifier.
Verify that the status LED light turns on.
1232038-2-A
Parallel Connection - 8 Ohm
- + + - -
+ -
Or
+ +
- -
+
- +
-
R L
10
+ + - - +
- +
R L
Kohler Co.