Black & Decker BDCHD18 Traduction Des Instructions D'origine page 7

BLACK+DECKER Service Centre in order to
avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Forward/reverse slider
3. Torque adjustment collar
4. Keyless chuck
5. Dual range gearing
6. LED work light
7. Battery
8. Battery release button
9. Screwdriver bit holder
Assembly
Use
Warning! Let the tool work at its own pace. Do
not overload.
Charging the battery (fi g. A)
The battery needs to be charged before fi rst use
and whenever it fails to produce suffi cient power
on jobs that were easily done before. The battery
may become warm while charging; this is normal
and does not indicate a problem.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Recommended charging temperature: approx.
24 °C.
Note: The charger will not charge a battery if
the cell temperature is below approximately
10 °C or above 40 °C. The battery should
be left in the charger and the charger will
begin to charge automatically when the cell
temperature warms up or cools down.
♦ Plug the charger into any standard 230 Volts
50 Hz electrical outlet.
♦ Slide the battery pack into the charger as
shown in fi g. A.
♦ The green LED will fl ash indicating that the
battery is being charged.
♦ The completion of charge is indicated by the
green LED remaining on continuously. The
pack is fully charged and may be used at this
time or left on the charger.
Warning! fi re Hazard. When disconnecting the
charger from the tool, be sure to unplug the
charger from the outlet fi rst, then disconnect the
charger cord from the tool.
All manuals and user guides at all-guides.com
Installing and removing the battery pack
from the tool (fi g. B)
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery.
To install battery pack:
♦
Removing the battery pack from the tool
(fi g. C)
♦
Operating Instructions
Trigger switch & reversing button
♦
♦
♦
♦
Note: The center position of the control button
locks the tool in the off position. When changing
the position of the control button, be sure the
trigger is released.
Torque control (fi g.D)
This tool is fi tted with a torque adjustment collar
(3) to select the operating mode and to set the
torque for tightening screws. Large screws and
hard workpiece materials require a higher torque
setting than small screws and soft workpiece
materials.
♦
♦
♦
♦
♦
ENGLISH
Insert battery pack into tool, until an audible
click is heard (fi g. B)
Depress the battery release button as shown
in (fi g. C) and pull battery pack out of tool.
The drill is turned ON and OFF by pulling and
releasing the trigger switch (1). The farther the
trigger is depressed, the higher the speed of
the drill.
A forward/reverse control button (2)
determines the direction of the tool and also
serves as a lock off button.
To select forward rotation, release the trigger
switch and depress the forward/reverse
control button to the left.
To select reverse, depress the forward/
reverse control button the opposite direction.
For drilling in wood, metal and plastics, set the
collar to the drilling position symbol
For screwdriving, set the collar to the desired
setting. If you do not yet know the appropriate
setting, proceed as follows:
Set the collar to the lowest torque setting.
Tighten the fi rst screw.
If the clutch ratchets before the desired result
is achieved, increase the collar setting and
continue tightening the screw. Repeat until
you reach the correct setting. Use this setting
for the remaining screws.
7