Before Use - Hilti AG 125-19SE Mode D'emploi

Thread length
Weight in accordance with EPTA procedure 01
5.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values
Sound (power) level (L
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Surface grinding with the vibration-absorbing side handle (a
Sanding (a )
h,DS
Uncertainty (K)
6

Before use

CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
6.1 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.2 Guard
▶ Observe the instructions for fitting the applicable guard.
6.2.1 Installing the guard
The guard is keyed to ensure that only guards of a type suitable for use with the product can be
installed. The keyed locating lug also prevents the guard from coming into contact with the tool.
1. Fit the guard on to the arbor collar so that the two triangular marks on the guard and on the product are
in alignment.
2. Press the guard on to the drive spindle collar.
3. Press the guard release button and turn the guard until it engages in the desired position.
◁ The guard release button jumps back.
6.2.2 Adjusting the guard
▶ Press the guard release button and then rotate the guard until it engages in the desired position.
2143513
*2143513*
)
WA
)
pA
)
pA
6
7
AG 125-19SE
22 mm
2.5 kg
AG 125-19SE
103 dB(A)
92 dB(A)
3 dB(A)
AG 125-19SE
) 4.9 m/s²
h,AG
2.7 m/s²
1.5 m/s²
English 25