Auping Royal 300 Mode D'emploi page 33

GB10
Adjusting motors (fig. 1)
1.Press one of the release buttons.
2.Press an 'up' or 'down' button.
Keep it pressed until the desired
position has been reached.
You can only adjust one motor at a
time.
Storing a pre-set position (fig. 2)*
The remote control unit is equipped
with an electronic memory. These
pre-set positions can be called up
using the memory buttons. All the
motors are engaged simultaneously
until each one has reached the pre-
set position.
1.Press a release button and keep it
pressed until step 4 has been
carried out.
2.Adjust your bed to the position you
wish to store in the memory.
3.Briefly press the programming
button and then release it again.
4.Press the memory button under
which you wish to store the pre-set
position within two seconds.
A short high-pitched beep confirms
that the set position has been
stored.
* If applicable
1 2
1 2
3 4
fig. 1
fig. 2