Installing The Appliance - Ashley DVAG11 Mode D'emploi

IMPORTANT:
INSTALLATION AND
DONE BY A QUALIFIED SERVICE PERSON.
THE APPLIANCE SHOULD
BEFORE USE AND AT LEAST ANNUALLY
BY A QUALIFIED SERVICE PERSON. MORE
FREQUENT CLEANING MAY BE REQUIRED
DUE TO EXCESSIVE LINT FROM CARPETING,
BEDDING MATERIAL, ETC. IT IS IMPERATIVE
THAT CONTROL COMPARTMENTS, BURNERS
AND CIRCULATING AIR PASSAGEWAYS OF
THE APPLIANCE BE KEPT CLEAN.
WARNING:
FAILURE TO POSITION
ACCORDANCE WITH THESE DIAGRAMS, OR
FAILURE TO USE ONLY PARTS SPECIFICALLY
APPROVED WITH
RESULT IN PROPERTY DAMAGE OR PERSONAL
INJURY.
HARDWARE PACKET CONTENTS
KEY DESCRIPTION
i Medium Screw
ii Large Screw
iii Washer
iv Spacer Washer
Rubber
v
Grommet
vi Small Screw
© 2021 United States Stove Company
REPAIR SHOULD
BE INSPECTED
THE PARTS
THIS APPLIANCE MAY
ITEM

INSTALLING THE APPLIANCE

Separate the hanging bracket from the appliance
BE
by removing two screws on the top and two nuts at
the bottom.
INSTALLING THE HANGING BRACKET
ON A NON-COMBUSTIBLE WALL ( I.E.,
MASONRY BLOCK OR CONCRETE)
1. Draw the position of the hole for the air-vent
intake pipe, taking into account the minimum
clearances
dimensions of the square hole "D" and height
to the center "C" in table 1 and figure 5 for the
different models. Height "C" is the minimum
recommended.
IN
MODEL
DVAG 11N -
DVAG 11L
DVAG 17N -
DVAG 17L
DVAG 30N -
QTY
DVAG 30L
2. Cut the square hole through the wall according
3
to the measurements and positions indicated
in figure 5.
4
D
4
4
C
2
8
8
INSTALLATION
mentioned in figure
TABLE 1
C
20-7/32" (514 mm)
11-1/4" X 11-1/4"
20" (508 mm) (286 x 286 mm)
square hole
25-7/16" (647 mm)
D
FLOOR
Figure 5
4. See
D