Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
:
Models
AK80LS, AK110LS
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
electric shock and injury to person, including the following:
1. Read all instructions before installing or using exhaust fan.
2. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
3. Before servicing or cleaning the unit, switch power off at
service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the
service panel.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-related construction.
5. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA)
and the American Society for Heating, Refrigeration, and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
CAUTION:
FOR GENERAL VENTILATING USE ONLY. DO
NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS
AND VAPORS.
210572072 Rev. A 8-05
OPERATING MANUAL
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. This unit must be grounded.
9. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off
power unit.
WARNING:
DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL
DEVICE.
10. Acceptable for use over a bathtub or shower when installed
in a GFCI protected branch circuit.
11. NEVER place a switch where it can be reached from a tub or
shower.
WARNING:
www.airkinglimited.com
Exhaust Fan
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
DO NOT USE IN KITCHENS
1 of 8

Publicité

loading

Sommaire des Matières pour AirKing AK80LS

  • Page 1 IMPORTANT INSTRUCTIONS - OPERATING MANUAL Models Exhaust Fan AK80LS, AK110LS READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2 INSTALLATION INSTRUCTIONS CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION. SECTION 1 Preparing the Exhaust Fan Unpack fan from the carton and confirm that all pieces are present. In addition to the exhaust fan you should have: Joist 1 - Grill Figure 3...
  • Page 3: Troubleshooting Guide

    1b. Internal Wire Compartment: Using a 7/16" socket, remove the two Carefully tuck wire back inside wire compartment and replace wire hex nuts holding the blower assembly in place. Lift up on the compartment cover securing with the screw that was removed earlier. assembly and slide it out of the tabs on the housing (Figure 6).
  • Page 4 5S1202005 Nuts 5S1202031 Blower Grommets 5S1202032 Internal Wire Cover 5S1202004 #10 Ground Screw 5S1999002 Motor Cap Harness - AK80LS 5S2202007 Motor Cap Harness - AK110LS 5S2202012 External Wire Cover 5S1202007 14 ga Ground Wire 5S1999003 Installer: _________________________________________________________ Installation Date:_________________________________________ Place of Purchase: _________________________________________________ Model Number: __________________________________________ 210572072 Rev.
  • Page 5 MANUEL D’OPÉRATION Modéles Ventilateur d’Évacuation AK80LS, AK110LS LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 6 INSTRUCTIONS D’INSTALLATION AVERTISSEMENT: VOUS ASSURER QUE L’ALIMENTATION EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER L’INSTALLATION. SECTION 1 Préparation du Ventilateur d’évacuation Sortir le ventilateur de sa boite et confirmer que toutes les pièces Solive sont présentes. En plus du ventilateur d’évacuation vous devriez avoir: Figure 3 1 - Grille 4 - Traverses de Montage...
  • Page 7: Guide De Dépannage

    1b. Compartiment de Câblage Intérieur: enlever les trois vis retenant Regrouper soigneusement les fils à l’intérieur du compartiment en place l’assemblage de la soufflante et soulever pour sortir pour le raccordement et replacer le couvercle du compartiment en le fixant avec la vis qui fut enlevée précédemment. l’assemblage hors du châssis (Figure 6).
  • Page 8: Garantie Limitée

    5S1202031 Passe-fil de la Soufflante 5S1202032 Couvercle de Câble Interne 5S1202004 Vis #10 de mise à la terre 5S1999002 Harnais du Capuchon du Moteur AK80LS 5S2202007 AK110LS 5S2202012 Couvercle de Câble Externe 5S1202007 Fil de mise à la terre 5S1999003 de calibre # 14 Installateur: ______________________________________________________ Date d’installation: _______________________________________...

Ce manuel est également adapté pour:

Ak110ls