Forno Alta Qualita FFSGS6211-30S Guide D'installation page 22

STEP 5: Gas valve (adjusting gas inlet orifice for surface burner)
After converting nozzle for different gas type, the gas inlet hole of surface burner needs to be adjusted.
5.1) Remove control knobs and knob base.
5.2) For the 9000BTU burner or 5000BTU burner (refer to the picture on the left), use screw driver the size is
2.0*50mm to adjust the burner bypass screw clockwise or anticlockwise, until the flame is normal.
5.2) For the 18000BTU burner or the burner for Bake (refer to the picture on the right), use screw driver the size is
2.0*50mm to adjust the burner bypass screw clockwise or anticlockwise, until the flame is normal.
5.3) Put back the knobs and knob base to the correct position.
STEP 6: Reconnect Gas and Electrical Supply
Leakage testing of the range shall be conducted according to the installation instructions provided with the range.
Before operating the range after the gas conversion, always check for leaks with a soapy water solution or other
acceptable method at gas connections installed between the gas inlet pipe of the range, gas regulator, and the
manual shut-off valve.
Use soapy solutions to check for leakage on all joints.
WARNING
DO NOT use a flame to check for gas leakage.
STEP 7: Installation of LPG Conversion Label
Record the model and serial number on the LP / Propane Conversion Label provided in this kit.
The information can be obtained from the existing Rating / Serial label. Place the LPG conversion label as close as
possible to the existing Rating / Serial label on the range.
Preparation
Before moving the range, protect any finished flooring and secure oven door(s) closed to prevent damage.
The oven door(s) can be removed to lighten the load or to fit the unit through a doorway. Only remove if necessary.
Do not remove the griddle or any other component. Door removal should only be done by a certified installer or
service technician.