Language; Contrast; Channels - Consort R361 Mode D'emploi

Language

Contrast

Channels

3
1. Press SET.
2. Select [SYSTEM] and press CAL.
3. Select [LANGUAGE] and press CAL.
4. Select the desired language and press CAL.
1. Press SET.
2. Select [SYSTEM] and press CAL.
3. Select [CONTRAST] and press CAL.
4. Adjust the contrast and press CAL.
1. Press SET.
2. Select [CHANNELS] and press CAL.
3. Select the desired ranges [INPUT] and press CAL.
4. Select the desired inputs [ATC] (automatic temperature compensation) and
press CAL.
5. Select [CONTROL] (yes or no) and press CAL.
6. Select the control type (on/off or proportional) and press CAL.
7. Pre-set the desired low level (Lo) and press CAL.
8. Select the corresponding relay (REL) and press CAL.
9. Pre-set the desired high level (Hi) and press CAL.
10. Select the corresponding relay (REL) and press CAL.
11. Pre-set the desired hysteresis (Hy) between the on and off state of the relays
and press CAL.
12. Pre-set the desired delay (dt) after which the relays should be activated, when
one of the pre-set levels is exceeded and press CAL.
Proportional control only:
13. Pre-set the desired the proportional control area (dP), in which proportional
regulation should start and press CAL.
14. Pre-set the desired pulse-time (Pt) of the relays and press CAL. The relays will
pulse at a rate proportional to the regulation difference.
Optional alarm procedure:
15. Select [ALARM] and press CAL.
16. The display shows the alarm time after which the process control should be
interrupted in case of a failure. Pre-set the desired alarm-time and press
CAL.
17. Select the corresponding relay (REL) to be closed in case of an alarm and press
CAL.
Optional maintenance procedure:
18. Select [MAINTENANCE] and press CAL.
19. The display shows the interval for a regular maintenance. Pre-set the desired
interval and press CAL .
20. Pre-set the desired waiting period before the beginning of the maintenance
and press CAL.
21. Select the corresponding relay (REL) and press CAL.
22. Pre-set the maintenance time and press CAL.
23. Pre-set the desired waiting period after the finish of the maintenance and
press CAL.
24. Pre-set the desired date and time when the first maintenance should start and
press CAL.
• The process control will automatically be interrupted during each mainte-
nance period!
R361 • R362 • R363