Personal Safety; Personal Protective Equipment - Pro-Point 8784720 Mode D'emploi

8784720
5. Do not install or use in the presence of flammable gases,
dust or liquids.
6. Welding sparks and ejected molten slag can start a fire.
Remove combustible materials within 39 ft (12 metres) of
the welding unit. See Fire and Explosion Precautions.
7. Have a fire extinguisher readily available (see Fire and
Explosion Precautions).
8. Keep the welding unit at least one foot from any wall
or structure.
9. Check that the work area is free from fires, sparks or hot
debris before leaving.

PERSONAL SAFETY

WARNING! Wear personal protective equipment approved by
the Canadian Standards Association (CSA) or American
National Standards Institute (ANSI).
1. Remove any combustibles, such as a butane lighter or
matches from your person before doing any welding.
2. Wear dry, hole-free insulating gloves and body protection.
3. Do not touch hot parts with bare hands.
4. Allow cooling period before working on equipment.

PERSONAL PROTECTIVE EQUIPMENT

1. Always wear impact safety goggles that provide front and
side protection for the eyes.
2. Wear gloves that provide protection based on the work
materials or to reduce the effects of tool vibration.
3. Non-skid footwear is recommended to maintain footing
and balance in the work environment.
4. Wear a safety harness if working above floor level.
4
220V SPOT WELDER
For technical questions call 1-800-665-8685
V1.0