Power Cord - Pro-Point 8784720 Mode D'emploi

8784720
3. Disconnect the power source before installing or servicing
the tool.
4. Keep hands and fingers away from the work area. Any
part of body contacting the tool's working parts could
cause an injury.
4.1 Keep away from pinch points.
4.2 Do not put hands between tips.
5. Never touch the tool accessory or workpiece during or
immediately after use. They may be hot and could inflict a
burn injury.
6. Do not touch the electrode or welded surface immediately
after use. The surface will be hot and may cause an injury.
7. Take work breaks to prevent the tool's motor from
overheating and/or overloading. Refer to the welding unit's
duty cycle in Specifications.

POWER CORD

1. Insert the power cord plug directly to the power supply
whenever possible. Extension cords are not recommended
for use with this welding unit.
1.1 Use a welding extension cord designed to exceed the
welding unit's maximum power requirements when an
extension cord is required.
2. Do not operate this tool if the power cord is frayed,
damaged or poorly spliced, as an electric shock may occur,
resulting in personal injury or property damage.
2.1 Inspect the tool's power cord for cracks, fraying or
other faults in the insulation or plug before each use.
2.2 Discontinue use if a power cord feels more than
comfortably warm while operating the tool.
3. Keep all connections dry and off the ground to reduce the
risk of electric shock. Do not touch the plug with wet hands.
12
220V SPOT WELDER
For technical questions call 1-800-665-8685
V1.0