Wifi Settings - DA-GEN DRYDEN AQUA GENERATOR Mode D'emploi

Green LEDs
(ON)
Connection
WIFI module
red
1
green
3
15.1
15.6
Once the WiFi module is connected to the network with both lights ON, enter
in www.DA-GEN.com. Access the Register option and enter all the data
requested.
15.10 - 15.13 The system node ID that you will need for the registration
progress is located under System settings > System info > Power module
Upon completion of the process, you will have total control of your pool, will be
able change parameters such as setpoints, filtration hours and turn ON/OFF any
auxiliary relays.
Attention: If the DA-GEN was once registered at vistapool.com it needs
to be removed there by the manufacturer before you can register it at
DA-GEN.com. Please contact your dealer.
Cover
1 & 5
3
4
5
6
7
8

15. WIFI SETTINGS

Installation Advice- Connecting the WIFI to the DA-GEN
Open the WIFI box and unscrew the cabels in the box. Put the cable through the cable hole at the
DA-GEN controller box and plug it in. Connect the cable then again in the WIFI box and close it
Do not remove the cables from the plug!
yellow
2
black
4
15.2
15.1 Internet: Once the WiFi module is connected, restart the unit. The internet option will appear in the settings menu.
15.7
15.2 WiFi: Select WiFi to scan the available networks accessible to the module. The search will be done automatically.
15.3 Select the desired network accessible to the WiFi module.
15.4 Enter the password in the pop-up keyboard. Scroll up and down with the up/down keys and left to right with the
plus/minus keys. To select a letter press OK.
15.5 Enter AP: If you do not find your Network in the automatic mode, then you can enter the network name manually.
Check first if the network works on other devices.
15.6 Status: Check the status of your connection.
15.7 Test connection: Check if your connection has been successfully established.
17.1 17.2
15.8 15.8
17. COVER
17. COVER
17.1 Cover: If the DA-GEN is runned with a frequency controlled pump and if it is connected
to the pool cover, the filtration speed will automaticly go to «medium» when the cover is
opened. (Please check the filtration speed in Chapter E). Set the Reduction value to 0%!
How to install: If the cover is open, the contact has to be closed and vice versa
7
15.5
15.9 15.10
EN