Safety Instructions; Electrical Connection - Electrolux ERW0273AOA Manuel D'utilisation

• Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning pads,
solvents or metal objects.
• Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarlyqualified persons in order
to avoid a hazard.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged ap-
pliance.
• Obey the installation instruction sup-
plied with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Make sure the air can circulate around
the appliance.
• Wait at least 4 hours before connect-
ing the appliance to the power supply.
This is to allow the oil to flow back in
the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where
there is direct sunlight.
• Do not install this appliance in areas
that are too humid or too colds, such
as the construction appendices, ga-
rages or wine cellars.
• When you move the appliance, lift it
by the front edge to avoid scratching
the floor.
ELECTRICAL CONNECTION
WARNING!
Risk of fire and electrical shock.
WARNING!
When positioning the appliance,
ensure the supply cord is not
trapped or damaged.
WARNING!
Do not use multi-plug adapters
and extension cables.
• The appliance must be earthed.
• All electrical connections should be
made by a qualified electrician.
• Make sure that the electrical informa-
tion on the rating plate agrees with
the power supply. If not, contact an
electrician.
• Always use a correctly installed shock-
proof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the electrical components (e.g. mains
plug, mains cable, compressor).
Contact the Service or an electrician to
change the electrical components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the installa-
tion. Make sure that there is access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
• When positioning the appliance,
ensure the supply cord is not trapped
or damaged.
• Do not locate multiple portable socket-
outlets or portable power supplies at
the rear of the appliance.
ENGLISH 31