Faro Ovni 33135 Installation Et Mode D'emploi page 12

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / Ο∆ΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
INSTALLING THE FAN
HANGING THE FAN
1. Be sure your mounting bracket
is secure. The entire weight of the
fan will now be hanging from it.
2. Lift fan /downrod/ball assembly/
into hanger bracket opening.
NOTE: the tab opposite hanger
bracket opening should fit into slot
on ball (fig. 3)
3. Make wire connections, (refer
to section titled "electrical
connections". Fan can be
operated by a fan wall control OR
by the supplied remote control.
4. Slide canopy up and fasten to
hanger bracket with screws
provided AFTER all electrical connections are complete.
ATTACHING THE BLADES
1. Insert blades thought slots in side of fan motor and align blade holes with holes in motor. (If holes do not align, then blade is upside
down).
2. Start blade screws with fiber washer into each hole. DO NOT TIGHTEN UNTIL BOTH SCREWS ARE STARTED. Repeat for
remaining blades.
3. Tighten all 10 blades screws evenly and securely to ensure quiet, wobble-free operation of your fan.
ATTACHING THE GLASS
Put 2 bulbs E27 20w (CFL)
ELECTRICAL CONNECTIONS
GENERAL INFORMATION
Instaling fan using the remote control:
The remote control's receiver, when installed inside the fan's canopy, will restrict the full tilting movement of the mounting ball therefore
limiting the maximum ceiling slope allowable lo 15 degrees. This is equivalent to a "3/12 ceiling pitch. If greater pitch is needed it is
recommended that wall control installation method shown on previous page be used.
INFORMATlON AND OPERATING INSTRUCTlONS
1. Setting the code:
This unit has 16 different code combinations, to set the code perform these steps:
A. Setting the code on the TRANSMITTER:
a. Remove battery cover. Press firmly and slide battery cover off.
b. Slide code switches to your choice position. Use a small screwdriver or ball point pen to slide each switch firmly up or down.
c. push "D" for dimmer option.
d. put the battery cover on
e. Turn fan power on, press and hold OFF button in front of remote for 5 seconds within 60 seconds of powering fan in order to
synchronize with the fan.