Beko CEG 3192 B Mode D'emploi page 22

7
Troubleshooting
Problem
The appliance does not work.
No or delayed response in several trials
of pressing a function key on the panel
The coffee is not hot enough.
The coffee cannot come out from spout. Empty system function maybe used
The first cup of coffee is poor quality.
The water tank is removed / the water
level is very low in the water tank but
there' s no alert.
The internal drip tray is filled with a lot
of water.
Coffee is delivered too slowly or a drop
at a time.
The indicator flashes that there's not
enough coffee beans, but there are
plenty inside the container.
The brewer or the coffee ground tray is
impossible to remove.
The appliance no longer performs the
rinsing cycle when switched on or off.
The touch buttons are not sensitive.
22 / EN
Cause
The appliance is not connected to the
mains.
Appliance is under an electromagnetic
interference. Dirt over the panel.
The cups have not been preheated.
The brewing unit is too cold.
before.
Coffee spout may not have been
cleaned and blocked by coffee residues.
The first run of the grinder does not
pour a sufficient quantity of coffee into
the brewing unit.
The area near the water tank connector
is wet.
The ground coffee is too fine, which
blocks the water from coming out.
Coffee grounds are too fine, which
blocks the water from coming out.
The internal coffee grounds outlet is
blocked.
The appliance did not finish the self-
cleaning process and was switched off .
Improper handling when servicing the
appliance may be the cause.
Not pressing the touch button from the
front direction of the appliance.
Fully Automatic Coffee Machine / User Manual
Solution
Plug in and press the switch. Check the
cable and the Plug.
Unplug the appliance. Restart after a
few minutes Clean the panel with the
cloth provided.
Warm up your cup by using steam func-
tion before you make coffee or rinse the
cup with hot water.
Make sure that the water in the water
tank is not too cold.
Press the hot water button until water
can come out from the spout.
Clean the coffee spout.
Throw the coffee away. The next cups
will be better.
Wipe off the water around the water
tank connector.
Adjust the coffee fineness to bigger dot
during grinder operation.
Adjust the coffee fineness to bigger dot
during grinder operation.
Follow the steps described for Cleaning
coffee grounds outlet.
Please switch on the machine again and
let it finish its auto cleaning process.
1. When the appliance is on, remove the
service door.
2. Press and hold the on/off button until
you hear 2 beeps.
3. Replace service door.
Press the lower bottom part of the icon
of the touch button from the front di-
rection of the appliance.