Endress+Hauser Prothermo NMT81 Mode D'emploi page 49

Prothermo NMT81
Water level offset
Navigation
Description
Entrée
Réglage usine
Product type
Navigation
Description
Sélection
Réglage usine
Three layer detection
Navigation
Description
Sélection
Réglage usine
Water bottom frequency ratio
Navigation
Description
Affichage
Endress+Hauser
 Application → Capteur → WB settings → Water offset
Enter an offset to adjust the output value of the water bottom probe.
–100 ... 100 m
0 m
 Application → Capteur → WB settings → Product type
Use this function to set the correct product beside water, in which the probe will be used.
• No product
• Essence
• Crude oil
• Gasoline
• Diesel oil / Kerosene
Selon les références de commande
 Application → Capteur → WB settings → Layer detection
Activate this function if the product level can move below the top of the water bottom
probe, so that air as a third layer is present at the probe.
• Désactiver
• Activer
Activer
 Application → Capteur → WB settings → WB freq. ratio
Shows the raw value of the water bottom sensor which is used to determine the water
level.
0 ... 2
Description des paramètres de l' a ppareil



49