Kohler K-6356 Guide D'installation page 3

Faucet Body
Threaded Hole
Mounting Stud
1. Install the Mounting Stud
Screw the mounting stud into the threaded hole at the bottom of
the faucet body. The mounting stud should extend slightly
beyond the threaded hole in the body.
For 1-hole Installations:
NOTE: The escutcheon, spacer, and O-ring are not required.
Slide the rubber washer over the faucet tubing and hose.
Insert the faucet tubing and hose into the hole.
2. Install the Escutcheon (Optional)
NOTE: For installation on marble, do not use plumbers putty. Use
the self-adhesive gaskets provided. Remove the paper backing and
apply the gaskets (adhesive side down) over the outside holes.
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheon according to the manufacturer's instructions.
Insert the O-ring into the groove of the spacer.
Slide the rubber washer, escutcheon, and spacer (O-ring side
down) over the faucet tubing and hose.
Insert the faucet tubing and hose into the center hole, carefully
aligning the escutcheon.
Press down on the escutcheon. Remove any excess putty.
Kohler Co.
Faucet Body
Rubber
Washer
Escutcheon
3
Spacer and
O-Ring
1025491-2-C