Maintenance; Cleaning Pad - ECOVACS ROBOTICS WINBOT X Manuel D'instructions

3. Maintenance

3. Maintenance

Cleaning Pad

a. Replace Cleaning Pad
Pause WINBOT. Remove the dirty cleaning pad and insert a new one
in the correct orientation.
* The dark side of Cleaning Pad faces outwards. Make sure the side
with is attached to WINBOT Cleaning Pad Plate with the same
18
EN
b. Clean the Cleaning Pad
Remove the Cleaning Pad from WINBOT. Immerse the Cleaning Pad
in lukewarm water for about 2 minutes, and rub a soft brush along the
grooves on the cleaning pad to remove dirt. Fold the Cleaning Pad
and squeeze it gently to remove excess water, and then place it in a
flat position to dry.
.
* Do not squeeze the pad with excessive force or hang it up to dry as
it may cause it to lose its shape and impair its ability to absorb dirt.
* Do NOT use a damp Cleaning Pad on WINBOT. This helps to prevent
the robot from sliding out of position during use.
* If the Cleaning Pad becomes worn or no longer fits exactly within the
fastener area, replace it with a new one to achieve optimal cleaning
performance.