Product Description; Before Use - Vestfrost ULTF-37i Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6
6
Vestfrostsolutions.com
Vestfrostsolutions.com
WARNING:
The appliance must be connected to power minimum 12 hours
before using it for storage of medicine.
● Always keep the keys in a separate place and out of reach of children.
● Do not step on the lower panel to reach medicine in the top of the appliance.
● Before servicing or cleaning the appliance, unplug the appliance from the mains or dis-
connect the electrical power supply.
● If the supply cord is damaged, it must be replaced by the manufacturer, its service agent,
or similarly qualified persons in order to avoid a hazard.
● Relevant for Australia: Supply cord fitted with a plug complies with AS/NZS 3112.
● Frost formation on the interior evaporator wall and upper parts is a natural phenomenon.
Therefore, the appliance should be defrosted during normal cleaning or maintenance.
● Please note that changes to the appliance construction will cancel all warranty and prod-
uct liability.
● This device is intended to be used exclusively for medical products.
● If medicine is spilled in the appliance or the defrost water canal is has to be cleaned
immediately to avoid the medicine to evaporate to the surroundings.
● If the instructions is lost please contact your supplier of the appliance to have a new
instruction for use.
● If service needed to this device, please be aware of only using service personnel with
education in handling medical devices.
Flammable Material Storage Freezer
Sparkfree interior to reduce the risk of internal explosion.
Interior temperature range: +1°C to 15°C
The interior comprise this safety marking:
II 3G nA IIB T6
NOTE:
● Combustible materials may be stored inside cabinet. but the cabinet is not approved for
potential explosive areas.
● Combustible materials shall be stored in approved containers.
● Danger of sparks due to electrostatic discharge. Do not use a dry cloth to clean plastic
parts. Clean plastic parts with a damp cloth only!
EN
EN

PRODUCT DESCRIPTION

Before use

This user manual is intended for the following product models:
We recommend that you read this user manual before using the unit for the first time. Vestfrost
Solutions does not guarantee safe operation if the unit is used for anything other than its intended
use. Contents of the user manual can be subject to change without notice.
This manual should be considered an integral part of the unit and should be stored close to the
unit and be easy to access.
For current versions of the manual, please visit https://www.vestfrostsolutions.com/
Before operating your new appliance, please read the following instructions carefully:
1. Check to ensure the appliance has not been damaged during transport. Transport damage
should be reported to the transporter delivery.
2. The foil on the shelves must be removed before cleaning and using the unit.
3. Clean the inside of the cabinet using warm water with a mild detergent. Use a soft cloth and
rinse with clean water and dry thoroughly.
4. Allow the freezer to stay at an upright position for at least one hour before switched on.
5. Allow the freezer to operate at the desired temperature for a minimum of 12 hours before
loading.
A-weighted emission sound pressure level is below 70 dB(A)
Vestfrost Solutions
Vestfrost Solutions
Tabletop
ULTF-37i
7
7

Publicité

Table des Matières
loading

Table des Matières