Operation - Kärcher K 2 Entry Manuel D'utilisation

GFCI INSTRUCTIONS
1. Plug the Ground Fault Circuit Inter-
rupter (GFCI) into a working outlet.
2. Press "TEST", then press "RESET"
to assure proper connection.
Note: The actual appearance of the
GFCI may be different from this illus-
tration.

Operation

ATTENTION
Pump running dry
Damage to the device
If pressure does not build up in the de-
vice after 2 minutes then switch the de-
vice off and proceed according to the
instructions in chapter Troubleshoot-
ing guide.
High pressure operation
Note
 Maintain a spraying distance of at
least 12 inches (30 cm) when clean-
ing the painted surfaces.
 Do not position the spray wands
closer than 24 inches (60 cm) (or 2
feet) when washing a vehicle.
 Do not use the dirt blaster to clean
car tires, paint or sensitive surfaces
(e.g. wooden surface).
1. Insert the spray lance into the trigger
gun, and turn the spray lance by 90°
to lock it.
2. Set the device switch to "1/ON".
3. Unlock the lever on the trigger gun.
English 11