Important Safeguards - Hamilton Beach Commercial 58850 Mode D'emploi

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or
injury to persons, including the following:
1. Read all instructions.
2. This appliance is not intended for use by persons with
reduced physical, sensory, or mental capabilities, or lack of
experience and knowledge, unless they are closely supervised
and instructed concerning use of the appliance by a person
responsible for their safety.
3. This appliance shall not be used by children. Keep the
appliance and its cord out of reach of children.
4. Close supervision is necessary when any appliance is used
near children. Children should be supervised to ensure that
they do not play with the appliance.
5. To protect against risk of electrical shock, do not put cord,
plug, base, or motor in water or other liquid.
6. Unplug cord from outlet when not in use, before putting on or
taking off parts, and before cleaning.
7. Avoid contact with moving parts.
8. Do not operate any appliance with a damaged supply cord or
plug, or after the appliance malfunctions or has been dropped
or damaged in any manner. Supply cord replacement and
repairs must be conducted by the manufacturer, its service
agent, or similarly qualified persons in order to avoid a hazard.
Contact Customer Service for information on examination,
repair, or adjustment as set forth in the Limited Warranty.
9. The use of attachments, including canning jars, not
recommended or sold by the appliance manufacturer may
cause a risk of injury to persons.
10. Do not use outdoors.
11. Do not let cord hang over edge of table or counter or touch
hot surfaces, including stove.
12. Do not place on or near a hot gas or electric burner, or in a
heated oven.
13. Keep hands and utensils out of the jar and away from the
cutting blade, while blending or chopping food, to reduce the
risk of severe personal injury and/ or damage to the blender
2

IMPORTANT SAFEGUARDS

or available attachments (attachments may not be provided
with blender). A rubber spatula may be used but must be
used only when blender is not running.
14. Blades are sharp; handle carefully—especially when
assembling, disassembling, or cleaning blender jar.
15. Do not use a broken, chipped, or cracked blender jar.
16. Do not use broken, cracked, or loose cutting blade assembly.
17. Always operate blender with lid and filler-cap in place.
Remove filler-cap only for adding ingredients or to insert the
tamper.
18. When blending hot liquids or ingredients, remove filler-cap
from the lid. Use caution: spray or excess steaming may
cause scalding and burns. Do not exceed the 6-cup
(1420-ml) level. Always begin processing on lowest speed.
Keep hands and other exposed skin from the lid opening to
prevent possible burns.
19. Ensure cutter assembly is tight and secure to jar. Injury can
result if moving blades accidentally become exposed.
20. If the jar should twist or rotate when the motor is switched
ON, switch OFF (O) immediately and tighten jar in collar or on
blender base.
21. Do not leave blender unattended while it is operating.
22. To protect against risk of electrical shock, do not put cord,
plug, base, or motor in water or other liquid.
23. Do not use appliance for other than intended purpose.
24. Check that the appliance is OFF (O) before plugging cord into
wall outlet. To disconnect, turn the control to OFF (O); then
remove plug from wall outlet. To unplug, grasp the plug and
pull from the outlet. Never pull from the power cord.
25. CAUTION! In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on
and off by the utility.