Preparing The Opening - Monogram ZHU30RSTSS Instructions D'installation

PREPARING THE OPENING

1
APPROXIMATE COOKTOP
DIMENSIONS
X
30" models: 19 1/4"
36" models: 18 7/8"
Size Models
30" PHP7030DTBB
PHP9030DTBB
CHP90301TBB
ZHU30RTBB
ZHU30STSS
PHP9030STSS
CHP90302TSS
36" PHP7036DTBB
PHP9036DTBB
CHP90361TBB
ZHU36RTBB
ZHU36STSS
PHP9036STSS
CHP90362TSS
* Depth at rear of cooktop at conduit location.
Front
Baffle dimensions
2
CUTOUT DIMENSIONS OF THE
COUNTERTOP
To ensure accuracy, it is best to make a template
when cutting the opening in the counter.
28 1/2" (30")
33 7/8" (36")
length of cut
1-3/4" MIN. Between
rear edge of cutout
and the wall behind
the cooktop.
2-1/2" MIN. From
front edge of cutout
and front edge of
countertop.
4
Installation Instructions
Y
Cooktop
30" models: 28 1/16"
36" models: 33 3/4"
X Y Z Front
29 3/4" 21" 3 1/4"
29 7/8" 21" 3 1/4"
36" 20 1/2" 3 1/4"
36 1/8" 20 1/2" 3 1/4"
Baffle
5 3/16"
19 5/8 (30")
19 1/8" (36")
width of cut
Use a cabinet base
equal to or larger than
the nominal width of the
cooktop (30" or 36").
3
The following MINIMUM clearance dimensions
must be maintained.
13" MAX.
Depth of
unprotected
overhead
Z
cabinets
See label next
to name plate
for minimum
clearance to
Z Rear*
rear wall.
4 5/8"
2" MIN. Clearance from
4 5/8"
cutout to side wall on
the left of the unit
4 5/8"
If a 30" clearance between the cooking surface and
overhead combustible materials or metal cabinets
cannot be maintained, a minimum clearance of 24"
is required and the underside of the cabinets above
4 5/8"
the cooktop must be protected with not less than 1/4"
insulating millboard covered with sheet metal not less
than 30 gage (0.0125") thick. A ventilation hood may
be installed above the cooktop. See the ventilation
hood installation instructions for the appropriate
5"
dimensions and clearances.
4
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand heat
(up to 200°F) generated by the cooktop.
30" MIN.
Clearance from
countertop to
unprotected
overhead
surface
Wall coverings,
cabinets and
countertop must
withstand heat
up to 200°F.
2" MIN. Clearance
from cutout to
nearest vertical
wall or cabinet on
right side of the
unit below the 15"
MIN. clearance
height
15" MIN. Height
from countertop
to underside of
nearest cabinets
on both sides of
cooktop, including
any light rails
31-2001162 Rev. 1