Bartscher 286.626 Mode D'emploi page 20

The manufacturer declares that the appliances of their production meet the above mentioned EEC
directives and requires that installation be done observing the norms in force.
DESCRIPTION OF APPLIANCES
Electric chip scuttle
A sturdy steel structure on four feet, thus enabling the height regulation.
The vat is made of stainless steel and it is supplied with a properly moulded ramp, so that oil can be
easily drained from the vat. Heating is obtained through a special ceramic infrared radiator activated
by a power regulator, thus allowing to regulate the functioning frequency of the heating element.
An automatically rearmed safety thermostat ensures that the temperatures measured on the metal
surfaces where the heating element is placed do not exceed the limits.
Neutral cabinet
Doors for closing the compartment and creating a neutral cabinet are available for the standing
versions.
PROVISIONS FOR INSTALLATION
Place
It is advisable to install the appliance in a well-ventilated room or under an extractor hood. The
appliance can not be installed as a single unit. If the appliance is installed near a wall of
inflammable material, protective measures have to be taken (e.g. use of sheets of refractory
material), so to ensure that the temperature of the walls is within the established safety limits.
Installation
Installation operations, voltage conversions to other than the original, starting up the installation or
appliance, ventilation and maintenance has to be done following the manufacturer's instructions and
observing the norms in force, by qualified personnel, in compliance with the following provisions
(GB):
ƒ Health and Safety at Work Act, 1974
ƒ Codes of Practice, BS6173, 1982
ƒ The Building Regulations, 1985
ƒ The Building Standards Regulations, 1981
For others countries follow the relevant local rules for:
ƒ Building regulations and local fire prevention provisions
ƒ Safety norms in force
ƒ The Electrical Norms in force
ƒ The Fire Brigade rules
Pag. 19/36