Timer Control; Ember Bed - Dimplex Sil48 Manuel D'instructions

Operation
Heater Enable & Disable Function:
From the touchscreen controls touch and hold the Heat icon for 10 seconds. The
ember bed will flash 6 times to indicate that the heater function is disabled. When
the heat is disabled, pressing the Heat button will cause the ember bed to flash, but
the heater will not operate.
To enable the heater again, touch and hold the Heat icon for 10 seconds.
!
This function cannot be set with the remote control.
NOTE:

TIMER CONTROL

The Timer button is used to activate or deactivate the sleep timer.
Pressing the Timer turns the timer on and '8h' appears on the display. Pressing the
Timer a second time within 10 seconds will turn the timer off. To set the time, use
the Level Selection control to select the desired time from the following: 8h-1h-2h-
3h-4h-5h-6h-7h.
The fireplace will shut off after the selected time period. Switching the fireplace OFF
with the Power Button will clear any timer setting.

EMBER BED

The Ember Bed button changes the ember bed by cycling through the seven color
options: color rotation 'd1' and smoldering (fluctuating brightness) embers option
'd9'. With 'd8' through 'd2' displayed, the Level Selection button will adjust the
brightness of the ember bed from 3- High, 2-Medium, and 1-Low.
LEVEL SELECTION BUTTON
The Level Selection button is used to adjust the heat setting, as well flame and
ember bed brightness and timer setting. See relevant section for more details.
18
1
2
3
4
5
6