Replacing Components; Replacing Media Drives; Removing A Media Drive; Inserting A Media Drive - Sony Memory Stick UPA-PC500 Guide D'installation

Replacing Components

Replacing Media Drives

It may become necessary to replace the media reader or
the combo drive. Follow the procedures below to
remove or insert one of the media drives.
Note
Before removing or inserting a media drive, make sure
the unit and the peripheral devices are turned off. The
button is located on the rear of the unit.

Removing a Media Drive

1
Open the cabinet.
For details, see "To open the cabinet" on page 6.
2
When removing the media reader, disconnect it
from the USB ports on the unit.
When removing the combo drive, disconnect it
from the IDE port on the unit.
3
Pull the quick-lock pins on both sides of the media
drive directly outward 1, and then turn them 90
degrees 2 to lock them in the open position.
Media reader pins
Opening the quick-lock pins
10
Replacing Components
Combo drive pins
1
2
4
Remove the media drive from the bay.
The old media drive is now removed. To finish the
replacement, you need to insert a new media drive.

Inserting a Media Drive

1
Insert the new media drive into the appropriate bay,
aligning the holes in the sides of the drive with the
quick-lock pins.
2
Turn the quick-lock pins 90 degrees to lock them in
the closed position.
3
When inserting a media reader, connect it to the
USB ports on the unit.
When inserting a combo drive, connect it to the IDE
port on the unit.
4
Close the cabinet.
For details, see "To close the cabinet" on page 7.
Replacing the Receipt
Printer
It may become necessary to replace the receipt printer.
Follow the procedures below to remove or insert the
receipt printer.
Note
Before removing or inserting the receipt printer, make
sure the unit and the peripheral devices are turned off.
The button is located on the rear of the unit.

Removing the Receipt Printer

1
Open the cabinet.
For details, see "To open the cabinet" on page 6.