Burners; Troubleshooting - BLAZE BLZ-SB2LTE Guide D'utilisation Et D'entretien

Fuel (Gas) Conversion Instructions for BLAZE Gas Burners.
There will be an orifice conversion kit in each Side Burner appropriate for the opposite gas type. The
kit will include two orifices to be replaced.
CAUTION: This should only by performed by a licensed gas professional.

Burners:

You must remove the cooking grate to expose the main burners in the appliance.
1.
Pull up slightly on side burner head and rotate to the side. This will expose the orifice where
2.
the gas enters into the burner. (pic below)
Remove orifice and replace with orifice of desired gas type and reassemble.
3.
If unsure of full procedure please contact your dealer.
4.
Smell of Gas is Present
Burner Does Not Ignite
Yellow Flame
Plugged Orifice
No Gas To Burner
Version 1.0

Troubleshooting

Check for loose connections or cracks in the gas line. Perform a leak test
with soapy water or a leak testing solution. DO NOT TRY AND TEST WITH
A FLAME. If you find a leak, immediately shut off the gas supply and call a
gas professional to fix the problem.
igniting pin.
Check position of
Clean area where contact will be made from spark tip to burner. Make
sure there is a blue spark at the electrode tip to burner. Make sure the
wire is connected correctly. Make sure the orifice is free of any grease or
dirt. Make sure burner "slit" is aligned with igniter.
ALWAYS TURN OFF GAS WHEN TESTING
Color on flame should be mostly blue. There should be a yellow tip
but if flame is completely yellow, clean burner and substances
around burner to remove oil or debris on the burner burner pedestal
Remove orifice and clean with a fine wire.
Check shut off valve to see if it is in the ON position – gas may be turned
off.
BLAZE Instructional Book
Page | 32
It should jump over to the brass burner.