Fuel Conversion - BLAZE BLZ-SB2LTE Guide D'utilisation Et D'entretien

A video converting your blaze grill is located on the blaze website to assist with the below instructions,
(
www.blazegrills.com )
Convertible Gas Regulator (if applicable):
Currently all Natural Gas burners are supplied with a regulator which is appropriate for use with Natural Gas or
low pressure Propane.
1. When converting to Propane Gas, the most common Propane canister used is a smaller sized portable canister
(typically 5 gallons or 20 pounds).The pre-installed regulator will need to be converted to LP gas (see
below) and add a secondary low pressure hose and regulator with an outbound pressure set to
approximately 11" of water column pressure. If an individual is intending on using Propane provided from a
larger tank permanently installed on location, the regulator included with the appliance will only need to
be converted for use with LP fuel (see NG-LP Regulator Conversion below). Please be aware that this
included regulator can only withstand an inbound pressure of .5 PSI or roughly 14 inches of water
column pressure. Any higher pressure on location will have to be further regulated before connecting to
the regulator on the appliance. Please consult your local Propane gas provider to confirm the gas pressure
on the supply line feeding the appliance.
2. If converting to Natural Gas, a low pressure regulator with an outbound pressure set to 4" of Water Column
pressure must be used.
3. With either setup, remember to always check for gas leaks after the job is complete (see checking for gas leaks).

Fuel Conversion

CAUTION: This should only by performed by a licensed gas professional.
BLAZE Instructional Book
Page | 30