BLAZE BLZ-SB2LTE Guide D'utilisation Et D'entretien page 14

Please contact your dealer and use a licensed contractor or installer to convert your appliance to
•
the different gas type.
CHECK TO ENSURE THAT THE GAS SUPPLY HOSE DOES NOT COME IN CONTACT WITH ANY HOT
•
SURFACE, SHARP OR ROUGH EDGES OF THE APPLIANCE OR OUTDOOR KITCHEN CONSTRUCTION.
DO NOT KINK THE GAS LINE WHEN INSTALLING.
The self-contained LP system appliance is design certified to be used with a standard 20 lb., 12 1/4" diameter; 18"
high cylinder with right handed connection threads and this is the maximum size LP tank to be used. The
cylinder must be marked in accordance with the latest U.S. Department of Transportation specifications for LP
gas cylinders. (DOT. CFR49 or National Standards of Canada CAN/CSA-B359 Cylinders, Spheres and Tubes for
the Transportation of Dangerous Goods a Propane Tank with an ODP Overfill Prevention Device must be used at
all times.)
IMPORTANT: Never connect the appliance to an unregulated gas supply.
If there are local codes that apply to outdoor burners, you will have to conform to them. Installation must
conform with local codes or in the absence of local codes, to the National Fuel Gas Code, ANSI Z223.1/NFPA
54 and Natural Gas Installation Code, CSA B149.1. All Natural Gas installations must conform to local codes or
in the absence of local codes the national fuel gas code, ANSIZ2223.1a-‐1998.
If there are local codes that apply to outdoor burners, you will have to conform to them. Installation must
conform with local codes or, in the absence of local codes, with Propane Installation Code, CSA B149.1, or
Propane Storage and Handling Code, B149.2 as applicable.
Installation in Canada must be in accordance with the standard CAN/CGA- B149.2.
A licensed contractor or local gas company representative must perform all gas connections.
Ensure that the service supplying the appliance is fitted with a shut off valve conveniently positioned near the
appliance and giving ease of access.
The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during
any pressure testing of that system.
BLAZE Instructional Book
Page | 14