Foro LS7300 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
IMPORTANT SAFETY MEASURES
1.
The regulator must comply with the standard EN16129; For category I3+, the appliance
must use the butane 30 mbar regulator (reduced pressure: 28-30 mbar) or the propane 37
mbar regulator (reduced pressure: 37 mbar). For category I3B/P(30), the appliance must
use the LPG 30 mbar regulator(reduced pressure: 28-30 mbar). For category I3B/P(50), the
appliance must use the LPG 50 mbar regulator (reduced pressure: 50 mbar).
2. The hose must comply with the standard EN 16436 and the length of the hose should not
exceed 1.5 m.
3.
The minimum distance f rom unprotected combustible materials must be 2 m.
4. Change the gas cylinder in an amply ventilated area, away f rom any ignition source (candle,
cigarettes, other flame producing appliances ...).
5.
Check if the regulator seal is correctly f itted and able to fulf il its function.
6. Do not obstruct the ventilation holes of the cylinder housing.
7.
Close the gas supply at the valve of the gas cylinder or the regulator after use.
8. In the event of gas leakage, the appliance must not be used or if alight, the gas supply
must be shut off and the appliance must be investigated and rectif ied before it is used
again.
9. Check the tubing or the flexible hose (at least once per month and each time the cylinder
is changed).
10. If it shows signs of cracking, splitting or other deterioration it must be exchanged with a
new hose of the same length and of the equivalent quality.
11. Read the instructions before installation and use.
12. This appliance must be installed and the gas cylinder must be stored in accordance with
the regulations in force.
13. Do not obstruct the ventilation holes of the cylinder housing.
14. Do not move the appliance when in operation.
15. Shut off the valve at the gas cylinder or the regulator before moving the appliance.
16. The tubing or the flexible hose must be changed within the prescribed intervals.
17. Use only the type of gas and the type of cylinder specif ied by the manufacturer in these
instructions.
18. In case of violent wind particular attention must be taken against tilting of the appliance.
19. Keep the instructions for future reference.
20. Do not connect the gas cylinder directly to the appliance without a regulator.
21. The injector is assembled by manufacturer only.
FØRO LS7300 - MANUAL
6

Publicité

Table des Matières
loading

Table des Matières