Troubleshooting - Foro LS7300 Mode D'emploi

EN
TROUBLESHOOTING CHECKLIST
PILOT WILL NOT LIGHT OR STAY ON
• Ensure that the gas supply is turned on and the cylinder is not empty.
• Press the ignition button several times. Ensure to keep the main gas lever pressed for at least 10
seconds.
• If the ignition button stays stuck in, then lubricate with WD40 while the heater is not lit.
• Keep trying as air can get trapped in the pipes. It can take some time to purge all the air out of the
system.
• Check if glass or lava rocks or other debris are not covering the pilot.
• Check to see if any connections are loose and tighten them if required.
• Check to see if there is a leak in the gas hose. Replace it if required.
• Try lighting the pilot with a match or lighter if the spark electrode is wet or damaged.
• Ensure that the appliance is on level ground and completely vertical as the 'Overturn Shut Off
Device' may have been triggered.
BURNER WILL NOT LIGHT
When the pilot is lit, there should be no reason the main burner would not light.
• If the pilot is lit but the burner does not light, check if too much glass or lava rock is around pilot
assembly. This could block the pilot light from igniting the main burner.
• If the pilot is lit but the burner does not light, there could be damage to the control valve, which
would need to be replaced by a qualified technician.
• If the pilot is not lit, the flame failure device has cut off the gas supply. Wait for 3 minutes, then try
relighting the pilot.
• Ensure that the appliance is on level ground and completely vertical as the 'overturn shut off device'
may have been triggered.
MAIN BURNER SUDDENLY GOES OUT
• If the pilot is extinguished for any reason (sudden gust of wind or it started raining), then the main
gas supply is automatically cut off.
• Turn the control lever to the 'OFF' position and leave it there for 3 minutes before relighting the
pilot.
• Once the pilot is lit the main burner will work.
• The gas cylinder may be empty. If so, replace the cylinder with a full one.
• Ensure that the appliance is on level ground and completely vertical as the 'overturn shut off device'
may have been triggered.
FØRO LS7300 - MANUAL
16