Gas Requirements; Leakage Test - Foro LS7300 Mode D'emploi

GAS REQUIREMENTS

• Use propane or butane gas only.
• Always use the correct pressure regulator and hose assembly suitable for the gas cylinder. Contact
your local gas supplier for further advice if needed.
• Dented, rusted or damaged gas cylinders may be hazardous and should be checked by your gas
supplier.
• Never use a cylinder with a damaged valve connection.
• Never connect an unregulated gas cylinder to the heater.

LEAKAGE TEST

Gas connections on the heater are leak tested at the factory prior to shipment. A complete
leakage test should be performed at the installation due to possible mishandling in shipment
or excessive pressure being applied to the heater.
• Make a soap solution of one part liquid detergent and one part water. The soap solution can be
applied with a spray bottle, brush or rag. Soap bubbles will appear in case of a leak.
• The heater must be checked with a full cylinder.
• Make sure the safety control valve is in the 'OFF' position.
• Turn the gas supply from the cylinder to 'ON'.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on
and recheck.
• Never perform a leak test while smoking.
FØRO LS7300 - MANUAL
13
EN