Foro LS7300 Mode D'emploi page 12

EN FØRO LS7300 - MANUAL
12
GAS BOTTLE, REGULATOR & HOSE
The appliance requires a regulator with 8-10 mm inlet and a
gas hose of 50 cm. The heater works with butane, propane or
liquid petroleum gas in certain pressure, which is available
at garden centers, retailers and gas suppliers.
Please ensure that a suitable regulator with a minimum
flow rate capacity of 1.3kg/h and relevant supply pressure
is used. Please contact your local gas supplier for further
advice if needed. The gas hose should be checked regularly
to ensure it is in good condition. We recommend you to
replace it in accordance with standard practices. Gas cylinder
dimensions differ in different countries. Choose the one
which suits the dimension of the cylinder cabinet best. Use
propane or butane gas. Although the heater will work with
both propane and butane, there is a difference between the
two gasses. Butane cannot be used in temperatures below
5 °C, whereas propane can be used all year round.
Notice - Gas bottle chain: When the gas bottle is placed in the cabinet, the door chain must be
closed as shown in the picture below.
WARNING
It is extremely important that you do NOT route the gas hose directly under the burner. Do not
allow the hose to touch any part of the burner or heater. The hose should be located so that it
is not subjected to undue strain or placed where it could be damaged.