Checking The Water Dispenser Line(Optional); Installing The Water Dispenser Line - Atag KA2111DC Notice D'utilisation

bolt, then tighten the bolt again with the wrench
If you do not secure the nut firmly, the bolt may release.
CHECKING THE WATER DISPENSER LINE (
the water filter removes unwanted particles from your water. However, it does not sterilize or destroy
microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to
you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside
the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water
outlet.

INSTALLING THE WATER DISPENSER LINE

Parts for water line Installation
1
Connecting to the water supply line
1. first, shut off the main water supply line.
2. locate the nearest cold, drinking water line.
installation kit.
dispense about 1l to clear and prime the water filter.
18_
setting up
1
clockwise
3
to fix the nut in place
2
until it reaches the lower end of the
1 .
3
2
1
( OPTIONAL) )
3
CAUTION
The water line must be connected
to the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
4